![]() ![]() On start up the 'Hardware UMC Asio' indicator flashes red, I have tried various settings without success however if I set the engine to 'normal' in settings and then change back to 'swift' it works and will continue working until next PC reboot. If you're not getting audio recognized, make sure your guitar is plugged into the right port - this applies to all interfaces supported by this mod, and should be relatively obvious, but I managed to miss this for 15 minutes while trying to get the configuration right. Hi, I am using a behringer UMC404 HD with voicemeeter Banana. custom - use the buffer size specified in CustomBufferSize fieldĪdditionally, for future people who wander through here looking for solutions to the same issues I had - set Channel under to 0 for Input 1, 1 for Input 2, etc. ![]() I am experiencing problems as follows: The system pauses during playback, then it starts again on its own. ![]() The latest version of The driver was downloaded and installed along with Reaper DAW. host - use a buffer size as close as possible as that requested by the host application A Behringer U-Phoria UMC404HD is hooked up to the laptop as an audio interface. driver - respect buffer size setting set in the driver
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |